Wheel bearings are one of those trailer parts nobody thinks about until something goes wrong. When they do fail, it's rarely quiet. A collapsed bearing can lock a wheel, cook a hub, damage the axle and, in the worst cases, lead to a wheel-end fire or a wheel coming off on the road.
The good news is that bearings almost always give you warning before they let go. Here's what to look and listen for, and how to keep your trailers rolling.
Why trailer wheel bearings fail
Most bearing failures come down to a handful of causes:
- Lack of grease or the wrong grease. Old, dried out or contaminated grease can't protect the rollers and races.
- Water and dirt getting in. Worn seals let in moisture, road grime and dust. SEQ's wet season and wash-down bays don't help.
- Incorrect adjustment. Bearings set too tight run hot. Too loose, and they hammer themselves out.
- Overloading and heat. Heavy loads, long runs and hot summer road surfaces all put extra heat into the wheel end.
- Dragging brakes. A brake that isn't releasing properly adds heat straight into the hub and bearing.
Warning signs a bearing is on the way out
Drivers and yard staff are usually the first to notice. Encourage them to report anything that seems off, including:
- A grinding, growling or rumbling noise from one wheel that changes with speed
- One hub that's noticeably hotter than the others after a run
- Grease or oil slung across the inside of the wheel or tyre
- Smoke or a burning smell from a wheel end
- Play or wobble when the wheel is jacked up and rocked top to bottom
- Uneven or unusual tyre wear on one position
- Discoloured (blue or straw-coloured) metal around the hub
If you spot any of these, don't keep running the trailer and hope for the best. A noisy bearing can go from annoying to dangerous very quickly, especially on a loaded trailer at highway speed.
A quick walk-around check
This takes a couple of minutes at the end of a run and can save a lot of downtime:
- Carefully feel near each hub (not on it) to compare heat. One much hotter than the rest is a red flag.
- Look for grease leaks, damaged hub caps and wet or dirty seals.
- Check tyres for odd wear patterns.
- Listen as the trailer rolls out of the yard for any new noises.
- Note anything you find and book it in rather than leaving it for later.
How regular trailer servicing prevents failures
Bearing problems are far cheaper to fix on a scheduled service than on the side of the Gateway Motorway. A proper trailer service includes inspecting, cleaning and repacking or replacing bearings, checking seals, setting adjustment correctly and checking hubs, suspension and lights while the wheel is off.
It's also the right time to look at the brakes. Worn or dragging brakes and bearing issues often go hand in hand, so we check both together. If your trailer brakes need attention, see our truck and trailer brake repairs page.
How often your bearings should be serviced depends on the trailer, the axle manufacturer's recommendations, your loads and the kind of work you do. Trailers doing long highway runs, heavy haulage or regular water crossings will need more attention than lightly used units. If you're not sure where your trailers sit, talk to us and we'll help you set a sensible interval as part of your preventive maintenance plan.
Workshop or mobile, we've got you covered
Our new truck and trailer workshop in Lytton, minutes from the Port of Brisbane and the Gateway Motorway, is set up for full trailer servicing. If it's easier for us to come to you, our three mobile service trucks cover Brisbane, Logan, Ipswich, the Gold Coast and the rest of SEQ. And if a bearing does fail on the job during business hours, our breakdown repair team can help get you moving again.
Hearing a noise you don't like, or due for a trailer service? Call Bells Diesel Repairs on 0432 368 300 or book a service online. We're open Monday to Friday, 8am to 4pm, with weekends by appointment.