A ticking or tapping noise from the top of a diesel engine is easy to ignore when the truck still drives fine. But the top end – the camshaft, rocker arms, shafts and valve gear – works hard on every rotation, and small wear there can turn into a much bigger engine repair if it's left alone.
We recently carried out an engine top-end repair on the camshaft and rocker gear for a customer in Rocklea. With the rocker cover off, you can see how much is going on up there: the camshaft, bearing caps, rocker arms and adjusters all have to stay well oiled and correctly set to keep the valves opening and closing on time. Here's what to watch for, and why it pays to get it checked early.
What the top end of a diesel engine does
The camshaft controls when the intake and exhaust valves open. Depending on the engine design, it acts on the rocker arms either directly or through followers and pushrods. The rocker arms pivot on a shaft and push the valves open, and the valve springs close them again. Adjusters set the clearance (valve lash) between the rocker and the valve.
All of these parts rely on clean oil at the right pressure. When oil is old, low or contaminated, or service intervals stretch out, wear starts on the cam lobes, rocker shafts, bushes and adjusters.
Warning signs of camshaft and rocker gear wear
- Ticking or tapping from the top of the engine – often louder at idle or when cold, and it may change with engine speed.
- Loss of power or poor response – worn cam lobes or incorrect valve clearance can stop the valves opening fully.
- Rough running – one or more cylinders not breathing properly can feel like a misfire.
- More smoke than usual – poor combustion can show up as extra smoke under load.
- Metal particles in the oil – fine glitter in drained oil or on the filter means something is wearing.
- Oil leaks around the rocker cover – not wear on its own, but a good reason to have a look underneath.
Some of these symptoms overlap with injector, turbo or air intake problems, which is why a proper diagnosis matters before any parts are replaced.
Why it's worth acting early
Top-end wear rarely fixes itself. A worn rocker or loose adjuster can let valve clearance drift, which puts extra load on the camshaft, valves and valve seats. Caught early, the repair is often limited to the top end. Left too long, it can lead to damaged valves, a breakdown on the job and a much bigger repair bill.
Simple habits that protect the top end
- Stick to your oil and filter change intervals, and use the oil grade the manufacturer specifies.
- Have valve clearances checked at the intervals in your service schedule.
- Don't ignore a new noise – note when it happens (cold, hot, at idle or under load) and tell your mechanic.
- Fix rocker cover and other oil leaks before they drop the oil level.
Regular preventive maintenance is the cheapest way to keep the top end healthy, and if you run several trucks, a planned fleet maintenance schedule makes sure none slip through the cracks.
How we check and repair it
We start by listening to the engine, then use Jaltest diagnostics to check for fault codes and live data that point to an engine or fuel system issue. If the top end is suspect, the rocker cover comes off so the camshaft, rocker arms, shafts and adjusters can be inspected for wear and correct clearance.
Engine repairs can be done at our truck and trailer workshop in Lytton, a short run from Rocklea and the rest of Brisbane's southside, or on site with one of our three mobile service trucks where the job allows. If a truck won't run at all, our breakdown repair service is available during business hours.
Hearing a new noise from your engine?
Call Bells Diesel Repairs on 0432 368 300 or book a service online. We're open Monday to Friday 8am to 4pm, with weekends by appointment.